User's Manual

should be finished in programming mode. At this time, make sure the
transmitter to be programmed has not been screwed onto the valve yet
until the programming has been finished and the Monitor returns to
normal mode.
Each transmitter has 4 groups of ID, for example when program the
transmitter with ID of 001 001 001 158 to front right tire position, the
user only needs to input the last 3 digits “158”. Monitor will record the
rest 3 groups of ID automatically.
1. After powered the Monitor and the screen displays “NSP”, press P for
3 seconds to access the system programming mode, the first interface
is for ID programming as shown below:
2. Press any of the four arrow keys to choose the transmitter position
which needs to be programmed.
3. Then press S for 3 seconds to start programming and the digit flashes,
then press up or down arrow key to adjust the value.
4. Once finish programming of the first digit, press → to start
programming the second digit which flashes. Press up or down arrow