User's Manual

Hardware Preparative Procedure

Before You Use

1. To prevent damage to your installation it is important that all devices are

properly grounded.

2. Make sure that the power to all devices connected to the installation are

turned off. You must unplug the power cords of any computers that have

the Keyboard Power On function.

3. A computer connected to the KVM switch should only be powered on after

all of the connections to the device are made (DVI, USB and audio).

Cable Connection

To set up your AS-21DA / AS-41DA installation, do the following:

1. Plug your USB keyboard and USB mouse into the USB console ports located

on the unit’s rear panel.

2. Plug your console monitor into the DVI console port located in the unit’s

rear panel and power on the monitor.

3. Plug your microphone and speakers into the console microphone and

speaker jacks located on the unit’s rear panel.

4. Using a KVM cable set, plug the DVI connector into any available DVI

socket in the KVM port section of the switch, then plug the accompanying

USB, microphone and speaker connectors into their corresponding USB,