User's Manual

LCD KVM Console User Manual
57
 CAT5 port KVM Module Installation
To install a single-level KVM, refer to the following online diagrams (numbered in the order of steps on
the online graph) and do the following:
1. Plug your USB keyboard and mouse into the USB console port on the back panel of the switch.
2.Use a set of CAT5e / 6-wire connectors to plug into any available CAT5 Port on the switch.
3. Plug a CAT5e / 6-wire connector into the CAT5 connector on the Dongle module of the KVM, and
connect the corresponding VGA video connector, USB or PS2 connector of the Dongle cable to the
corresponding port on the PC.
4. Plug the power adapter supplied with this package into the AC power source, and plug the
other end of the power adapter into the power jack on the switch.
5. Connect the network cable to the IP port of the IP module.
6. Turn on the computer.
Note:1. Make sure that all plugs are connected to the same group of KVM connection port jacks (all
connected to Port1, or all connected to Port2).
2. The IP module is an optional module of the product. If the product you purchased does not
include the module, please ignore the related operation in Step 5.
3. Before using the IP module, please make the appropriate configuration and network debugging
after the access to the network you want to connect, or may fail to connect because of normal
remote control. (Refer to the manual of the IP module product manual for how to use and debug
the IP module.)
4
．
LCD KVM conversion module is divided into two types: PS2 and USB port, you can connect your
computer to choose the appropriate conversion module to use.
5
．
Make sure you are connecting to a computer and LCD KVM switches have a good grounding
protection altogether, or it may produce a video display problems
6
．
For display problems caused by transmission distance, electromagnetic interference, common
ground, etc., it is recommended to use Category 6 shielded network cable to connect and try to
improve the display effect