User's Manual

LCD KVM Console User Manual
57
 DVI port KVM module installation
To install a single-level KVM, refer to the following online diagrams (numbered in the order of steps on
the online graph) and do the following:
1. Plug your USB keyboard and mouse into the USB console port on the back panel of the switch.
2. Insert the audio cable plug of the microphone and the speaker into the corresponding type
port.
3. Using a set of DVI KVM cable connectors corresponding to this module to plug into any of the available
Port ports on the switch, DVI to DVI port, USB Type B to keyboard port, mouse port, composite audio
plug into the audio jack.
4. Connect the AC adapter to the AC power source, and plug the other end of the power adapter into the
power jack on the switch.
5. Connect the network cable to the IP port of the IP module.
6. Turn on the computer
Note:
1.LCD KVM conversion module is divided into two types: PS2 and USB port, you can connect your
computer to choose the appropriate conversion module to use.
2.Please make sure that the computer and the LCD KVM switch you are connecting to
have a good common earth ground, otherwise a video display problem may occur.
3.For display problems caused by transmission distance, electromagnetic interference,
common ground, etc., it is recommended to use Category 6 shielded network cable to
connect and try to improve the display effect.