User's Manual

LCD KVM Console User Manual
57
 CAT5 Port LCD KVM Switch Cascade
In switch cascade mode, the keyboard, mouse and computer connections and stand-alone connection is the
same, this part will not repeat them, the number part of the description is as follows:
1.The cascade KVM switch, have two connection methods, the use of USB KVM conversion module cable
or PS2 KVM conversion module cable and a switch to the next level to connect. (Refer to the description
of the CAT5 KVM switch product manual for how to connect the converter module.)
2.The number of computers connected to each level can be changed according to your needs. Refer to the
connection port shown in figure 2, which is the connection port of Remote Control mode. It can provide
the user to connect the control device through Remote Control console. Remote Control Port switcher
usage and connection method(Refer to the CAT5 KVM switch product manual for instructions.)
）
3.IP modules can be selected for remote control, and can also be controlled by local and remote KVM
switches from the upper layer as a unified control and management operation.
Note
：
This product cascade mode is divided into two levels, so you need to set two levels of OSD Menu
hotkey for two different hotkey combinations in cascade mode, otherwise the cascade connection can not
start the OSD normally. The OSD Hot Key settings are described in detail in the OSD chapter.)
Please make sure that your computer and LCD KVM switch are well grounded. Otherwise, the video
display problem may occur. For the display problems caused by transmission distance, electromagnetic
interference, common ground, etc., it is recommended to use Category 6 Screen cable to connect, try to
improve the display.