Instruction manual

GX301

SVAT ELECTRONICS

now you can see

No Picture/Signal • Make sure all the connections are secure and properly connected

• Make sure your receiver is plugged into a power source from the 9VDC input

on the back

• Make sure there is nothing obstructing the view of the camera

• Try re-pairing the camera and receiver

Picture too Bright/Dark • The night vision comes on automatically when the light levels drop; try the

camera in a pitch black setting. The area that the camera is in may get too

much light to activate the sensor

• Try adjusting the brightness settings on your receiver

No Audio • Make sure nothing is interfering with the microphone on the camera

• Make sure whatever you are trying to hear is close enough to the

microphone on the camera

• Disconnect and reconnect the wires from the camera and the receiver to

make sure they are secure

• Try re-pairing the camera and receiver

• Try adjusting the volume on the monitor that the receiver is plugged into

• Ensure that the camera volume is turned up using the remote

• Ensure that the AV cord is connected to the proper connections on the

receiver and on the monitor that the receiver is connected to

Buttons are not working • The buttons do not work in quad screen mode, ensure you are viewing full

screen

• Make sure the button lock function (on the front of the receiver) is not

switched on

Devices are not pairing • Ensure that the camera and receiver are within 100ft of each other

• Try moving the devices closer together, sometimes walls/other obstructions

can get in the way of the camera and receiver’s signal

• Ensure that both devices are connected to a proper power source

Night Vision not Working • The night vision comes on automatically when the light levels drop; try the

camera in a pitch black setting. The area that the camera is in may get too

much light to activate the sensor

Monitor is reading “No

Signal”

• Try re-pairing the camera and receiver

• Make sure there is nothing obstructing the view of the camera

• Make sure the camera and receiver are within 100 ft from one another

Footage not recording • Adjust what recording setting you are set to

• Make sure SD card is completely in the receiver

• Make sure SD card is not full and that overwrite function is turned on

• Make sure SD card is not locked by adjusting the tab on the side of the card

Remote not working • Ensure that the remote control has batteries inserted into it and that those

batteries are not dead

• Try plugging the IR sensor in

• Try using the remote control closer to the receiver

TROUBLESHOOTING