User's Manual

智能保温灯使用说明书
User Manual for Smart Heat Lamp
4
3. Assembly steps
1. Align the fixing screws of the
lamp holder with the fixing
holes at the top of the lamp
shade, and assemble the
two components;
2. After fixing the lamp holder
and the lamp shade, tighten
the screws with a cross
screwdriver
3. After aligning the lamp
thread with the lamp base,
turn the bulb clockwise, and
tighten and fix it to the lamp
base;
4. Remove the lamp protective
net, and install it into the
mounting groove, with one
end through the net limit
hole on one side of the lamp
shade;
5. The installation of the
protective net is completed;
6. Connect one end of the
hanging iron chain to the
lamp holder, and fix the
other end to the hanging
position;
7. The assembly of the heat
lamp is completed;
8. Note that the temperature
probe shall be installed 4 cm
below the edge of the lamp
Smart Heat
Lamp
Smart Heat
Lamp
Smart Heat
Lamp
Wireless
network
Ethernet
Server