Instruction Manual

ENG
6
Wireless Gamepad
• To check and configure in DirectInput mode, select
Properties in the Game Devices window, and the
Properties: USB Vibration Joystick (BM) window pops
up. In the «Test» tab, you can check the execution of
commands when you press the buttons and rotate
the joysticks, and also check whether the joystick is
connected to the PC in the «Connected State» line
(Fig.10).In the «Calibration» tab, you can center the
position of both joysticks (Fig. 10). To do this, you need
to set them to the middle position, then click «Default»
and «Set». After calibration, you must click «Accept»
or «OK» on the bottom line of this window to save the
changes.
• In the «Vibration Test» tab, you can check the
operation of both vibrators together by pressing the
«Both force» button; or separately, by pressing the «Left
force» and «Right force» buttons. And also by rotating
the left joystick in the analog mode of operation or
by pressing the 8-way joystick in the digital mode of
operation (Fig. 11). To stop the test, press the «Stop»
button. Moving the cursor in the row «Vibration
strengthv» we can increase or decrease the force of
vibration. To save the settings, click «Apply» or «OK» in
the bottom line of this window.
• The «About» tab provides information about the
version of the installed driver.
• The device can work in analog and digital modes.
The modes are switch by pressing the HOME button,
depending on the mode, the operation mode LEDs light
up. In digital mode, two axes are available (one LED on
the left is lit), and in analog mode all 4 axes (two LEDs
on the left are lit).
• With PS3.
• Connect the gamepad to an available USB port. The
system will automatically establish a connection, and
the LED corresponding to the number of the gamepad
in the system will light up.
• With Android.
• To connect to devices running Android, you need a USB OTG cable (not included). After
connecting the gamepad with this cable, the system will automatically establish a connection,
while the two rightmost LEDs will light up.
• Connector for charging.
• To switch between the «DirectInput» and «XInput» modes, you must press the HOME
button for 6 seconds. In the «DirectInput» mode, the second left LED lights up, and in the
«XInput» mode - the 3
rd
LED.