Owner's Manual

page 8 | owner’s manual
AC Power Connection
Connect the subwoofer power cord to the subwoofer amplifier and directly into an AC outlet.
Convenience outlets located on the rear panel of some AV receivers or pre/pros are NOT recom-
mended for your PB-3000 as these outlets are not meant for high power devices.
Line Level Connection – Single LFE Channel
The most common way to connect your PB-3000 is with a single RCA interconnect cable going
from the LFE or SUB1 Output on your AV receiver or preamplifier to the LFE Input on your
PB-3000. This allows your processor to perform the upstream bass management and send the
subwoofer a pre-filtered mono signal.
PB-3000
SUBWOOFER
CONNECTING & CONTROLLING YOUR SUBWOOFER
Line Level Connection – Stereo Receiver or Preamplifier Left/Right Channels
Both Left and Right inputs on your PB-3000 can be used in a two-channel stereo application with
a stereo preamplifier that has Left and Right line level or Balanced (XLR) outputs.
Connect the left and right outputs of your preamplifier to the left and right line level inputs of the
PB-3000 using RCA interconnects.
ONOFF
R
3V-12V | AC/DC
100V-120V ~ 50-60Hz 800W
+
VOL
LOW
PASS
LOW PASS
PHASE
PHASE
0°
90° 180°
30Hz 40Hz 60Hz 90Hz 140Hz LFE
_
LINE LEVEL
INPUT
TRIGGER INPUT
SVS SOUNDPATH WIRELESS
AUDIO ADAPTER
STA-800D|2
LFE
AUTO [amber]
ON [blue]
CENTER
REAR FRONT
SUBWOOFER
(SUB1)
LINE LEVEL OUTPUTS
INPUT
LFE
RECEIVER/PREAMP