Quick Start Guide

FCC Warning:
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the
equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of t
he FCC Rules.
These limits are designed to provide reasona
ble protection against harmful interferenc
e in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installat
ion. If this
equipment does cause harmful interference to radio or televisi
on reception, which can be determined by turning the equipment of
f and on, the
user is encouraged to try to correct the interferenc
e by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between
the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
SAR tests are conducted using standard operat
ing positions accepted by the FCC with the phone transmitting at its highest certi
fied power
level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level
of the phone
while operating can be well below the maximum value, in general, the closer you are to a wirele
ss base station antenna, the low
er the power
output.
Before a new model phone is a available for sale to the public, it must be tested and certified to
the FCC that it does not exceed the exposure
limit established by the FCC,
Tests for each phone are performed
in positions and locations (e.g. at the ear and worn on the bo
dy)as required
by the FCC.
For body worn operation, this model phone has been tested and meets the FCC RF exposure guidelines when used with an accessory
designated for this product or when used with an accessory that contains no metal and that positions the handset a minimum of 1
.0 cm from
the body.
Non-compliance with the above restrictions may result in violation of RF exposure guidelines.