Instructions / Assembly

ManualsBrandsSwan ManualsGranite Composite SinksDual Mount Composite 15 in. 1-Hole Bar Sink in White

BAR SINKS

TOOLS REQUIRED

• Ruler

• Drill

• Caulk

• Saber Saw

(if counter top

cutout is required)

BS-2515

BS-1515

1. If it is necessary to cut out

the counter top, invert sink

and position onto the counter

top. Locate sink front to rear

and so that the bowl will not

interfere with the cabinets

below. Trace a pencil line

around the outside edge of

the sink and remove the sink

from the counter top.

2. Measure in 5/16⬙ from the

initial sink outline and draw a

second line inside the first.

Draw a 1-1/2⬙ radius at each

corner. This second interior

line will be your cutout line.

Check Cutout

Line Measurements

Model Width Depth

BS-1515 14-3/8⬙ 14-3/8⬙

BS-2515 24-3/8⬙ 14-3/8⬙

Measure the cutout or the

pre-cut opening to be sure it

conforms to the sizes listed.

3. Drill starter hole inside of

cutout line.

4. Using a saber saw, cut

inside of cutout line. Trial fit

sink to check proper fit.

TRACE COMPLETELY

AROUND EDGE OF SINK

DRAW A 1-1/2ⴖ RADIUS

AT EACH CORNER

DRILL STARTER HOLE

INSIDE OF CUTOUT LINE

CUT INSIDE OF LINE

OWNER’S MANUAL

MODEL NOS.

BS-1515

BS-2515

Installation

Care and

Cleaning

CAUTION:

Read ALL instructions carefully

BEFORE starting your installation.

Save this manual for future reference.

5/16⬙

CUTOUT LINE

Summary of content (2 pages)

PAGE 1
BAR SINKS BS-1515 TOOLS REQUIRED • Ruler • Drill • Caulk • Saber Saw (if counter top cutout is required) BS-2515 TRACE COMPLETELY AROUND EDGE OF SINK DRAW A 1-1/2ⴖ RADIUS AT EACH CORNER DRILL STARTER HOLE INSIDE OF CUTOUT LINE CUT INSIDE OF LINE 5/16⬙ CUTOUT LINE 1. If it is necessary to cut out the counter top, invert sink and position onto the counter top. Locate sink front to rear and so that the bowl will not interfere with the cabinets below.
PAGE 2
BAR SINKS APPLY CAULK 5. Fixture hole locations are identified with a gray label indicating the most desired placement. Position a chisel on the desired dot and strike with a hammer to break out the hole. Clean out fixture hole with a knife. If hole is not used, peel off the label. Attach faucet, drain, and accessories according to manufacturer’s instructions. 6. Apply a bead of caulk (not included) to the underside of the sink flange and position sink into counter top opening. 7.