Installation Guide

Preparation Tips
 The mounting surface must be free of dirt, film,
waxes, or any other residues.
Caulking Tips
 Follow the instructions on the caulking tube.
 When job is complete, inspect all caulked areas for
gaps and fill as needed.
 Clean up any excess clear silicone using denatured
alcohol and a clean cloth.
 Be very careful not to disturb caulk joints.
Followed carefully, these installation instructions will
result in an easy, trouble-free installation of your
Swanstone product. Any deviations, additions, and/or
deletions from the prescribed installation, without prior
written approval, will void the warranty covering this
product. Not following the directions could also result in
personal injuries, water damage, and other damage to
floors, pipes, walls, and other portions of your building or
home.
Disclaimer
 The information contained in this Installation Manual
is given free of charge. It is based upon technical
data which we believe to be reliable and is intended
for use, by persons having knowledge of this
technical area, at their own discretion and risk.
Swanstone assumes no responsibility for results
obtained or damage incurred from the use of this
material either in whole or in part by the buyer.
 This manual will give you basic instructions for the
installation of the product in a step-by-step sequence
that will work in most types of installations. If you
have an installation application that is not covered in
this manual, please call your local Swanstone
distributor or contact The Swan Corporation directly
for additional information about your application.
 Follow all installation instructions. Failure to follow
these instructions could result in personal injuries,
water damage, or other damage to floors, pipes,
walls, or other portions of your building or home.
Corner Shower Seat Installation
The shower seat is a corner mount design that can add
comfort and convenience to your shower. It is designed
to coordinate with Swanstone tub & shower walls, floors,
and accessories. The molded run-off channel means
water will not pool on top of the seat.
This corner shower seat is designed to fit the following
Swanstone Wall Systems: SSIT-60-3, SS-72-3, SS-60-3,
SS-60-5, SSWP-4872, SK-363672, SK-324872,
SK-344872, SK-326072, SK-346072, SS-3672-3,
DK-363672, DK-324872, DK-344872, DK-326072, and
DK-346072. If you have questions on installing the
corner shower seat in other Swanstone wall systems,
please contact the Swanstone Customer Relations
Department.
The structural strength of the seat and the attachment
bracket, when properly installed on a structural wall,
will hold a maximum weight of 300 pounds. Check all
state and local codes for mounting requirements
before installation. Exceeding the maximum weight
limit will cause the seat to fail or the mounting
bracket to pull away from the wall, resulting in
serious injury.
NOTE: This product is designed so that the mounting
bracket is secured to a strong and stable surface. Any
application that doesn't allow for solid contact between
the mounting bracket and the in-wall support system is
unacceptable.
To prevent serious injury, it is critical that the 2x6 wall
supports be securely fastened to the stud wall. It is
the installers responsibility to make sure this wall
support will hold the 300 lb weight rating of the
shower seat.
1. The shower seat must be installed using sufficient
structural in-wall mounting blocks. A common
shower seat height is 19". A strong 2 x 6 inch wall
support must be installed 16-1/8", on center, off the
subfloor.
WARNING
WARNING
The Swan Corporation – Swanstone 6 800-325-7008
General Information Installation Procedure