Installation & Assembly

WARNING
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in serious injury or
death.
Electrical Shock Hazard
Contacting live electrical wiring with power tools
or hand tools can cause serious injury or death.
Make sure all related circuit breakers are turned OFF. Test for
live circuits or wiring inside any wall where installation of the
Swan Corporation product requires cutting into a wall.
Electrocution Hazard
Water and other liquids conduct electric current and
can create a short circuit, resulting in injury or
death. Keep all liquids away from electrical cords and power tools.
DO NOT create a short circuit between a source of electricity and
a liquid by being in contact with both simultaneously.
General Information
Required Tools
m 100% clear silicone sealant
m Saber saw (straight up and down travel) with bi-metal blade
(14 teeth per inch )
m Drill with 3/8 inch drill bit
m Hole saw for faucet(s), bathtub spout, and/or shower head
m Tape measure
m Masking tape (2 inch wide works best)
m Level
m Caulking gun
m Medium grit sandpaper
m Clean paper towels or shop towels
m Lumber, as required for bracing (see Bracing Instructions)
m Denatured alcohol
Veritek Wall Kit Contents
Confirm that all parts of the kit have been included before
beginning installation.
TF-57 Bathtub Wall Kit (Molded Design)
One back panel
One left corner panel
One right corner panel
Two side panels
One tube of color match silicone sealant
Designed for bathtub enclosures 58 to 60 inches wide and 28
to 30 inches deep. Wall panels are 57 inches high.
TI-5 Bathtub Wall Kit (Tile Design)
One left side panel with shampoo shelf
Two corner panels
One back panel with soap dish
One right side panel with shampoo shelf
One left side apron strip
One right side apron strip
One tube of color match silicone sealant
Designed for bathtub enclosures 53 to 60 inches wide and 29
to 32 inches deep. Wall panels are 59-5/8 inches high.
TI-3 Bathtub Wall Kit (Tile Design)
One back panel
Two side panels
One tube of color match silicone sealant
Designed for bathtub enclosures 53 to 60 inches wide and 29
to 30 inches deep. Wall panels are 59-5/8 inches high.
GN- 58 Tub Wall Kit (Natural Gloss Design)
One back panel
One left corner-side panel
One right corner-side panel
One tube of color match silicone sealant
Designed for bathtub enclosures up to 60 inches wide and 29
to 30 inches deep. Wall panels are 58 inches high.
TI-7260 Shower Wall Kit (Tile Design)
One back panel
Two corner panels
Two side panels
One tube of color match silicone sealant
Designed for shower enclosures 53-1/4 to 64-3/4 inches wide
and 31 to 36 inches deep. Wall panels are 71-5/8 inches high.
Note 1: Corner panels are different widths. Refer to chart in
Installation Instructions for correct orientation.
Note 2: Bull nose (curved) edges on side panels must face to
the outside of the shower for proper installation.
For best results, use 100% clear silicone sealant for bonding
this product to a properly constructed and prepared sub wall.
You will need one tube of 100% clear silicone sealant (tube
sized to fit a standard caulking gun) for every 1440 square
inches or 10 square feet, or, 4 to 10 tubes for an average
shower. Follow the application recommendation located in the
Panel Installation section of this manual.
Unpack Carton
m Use care when opening the box so that you do not damage
the panels.
m This product is shipped to you or your retail center after
careful inspection. After purchasing the kit, carefully unpack
and inspect the product for any shipping damage that may
have occurred. If damage is found, report it immediately
to the store of purchase. After inspection and during
installation, protect the products from construction damage
by moving them to another room or area until ready to install.
m Store panels in a flat area to avoid warpage until the time of
installation. Do not store the panels outside of the original
packaging in a vertical position.
m Please use the model number located on the side of the
box, or the front of this manual, when contacting us with
questions concerning the installation of this unit.
m Make sure the walls are the correct size and are in good
condition. Installation of damaged product will void the
warranty.
800-325-7008 5 Swan
General Information