Installation & Assembly

Helpful Hints
m Read these instructions carefully and familiarize yourself
with the various parts of the kit.
m The variety of installations possible for this kit may require
procedures other than those shown. Ensure construction is
correctly sized, plumb, and square.
m Save the large cardboard box for protection of the shower
floor or bathtub during the installation process and to use as
a template for cutting the wall panels.
m Allow sufficient time for the parts in this kit to adjust to room
temperature. We do not recommend installation of this
product at temperatures below 65°F.
m Sawhorses with 2 x 4 cross-members or a worktable are
helpful during the installation process.
m Always transport the panels vertically. Use care when
laying the panels flat to prevent flexing, especially when
panels have a cutout in them.
m Store unused materials away from the work area to prevent
accidental damage.
m If the shower or bathtub is placed over a garage or on an
outside wall, care must be taken to ensure that the shower
or bathtub is properly insulated from cold temperatures.
Preparation Tips
m Measure the width of the back wall (with green board)
installed. This measurement cannot exceed the width of
the Swan Corporation back panel(s). If the wall opening
is too small or too large, other methods will be required to
cover the wall.
m Measure the height above the bathtub or shower base.
If this measurement is less than the height of the Swan
Corporation back and side panels, then the panels must be
cut to fit.
m Turn off the hot and cold water supply.
m Remove faucet handles, escutcheons, filler spouts, and/or
anything mounted to the wall (i.e. towel bars, soap dishes,
etc.).
m Always measure the location of the plumbing cutouts, as
stated in the instructions for each specific Swan Corporation
tub wall kit. Make a cardboard template to trial fit all
plumbing cutouts before cutting panels.
m Ensure all plumbing or electrical work inside the walls is
finished prior to installation of the wall panels.
m Prepare the area with 1/2 inch (13 mm) moisture resistant
drywall, marine grade plywood, or concrete board. Never
install our products directly on any structure that is, or may
become, wet or damp.
m Trial fit the side panels before you begin. Swan Corporation
panels have a finished side and an unfinished backer side.
The unfinished backer side should be placed against the
sub wall.
m Walls must be solid, plumb, and square within 1/8 inch of
true. Shim or trim the opening, as required. This kit has
been designed with some adjustability for minor alignment
problems.
m The mounting surface must be free of dirt, film, waxes, or
any other residues.
m If you are installing a recessed accessory, cut the hole
after the panel is installed and fully supported by the wall.
Remember to position the accessory between the wall studs.
Caulking Tips
m Follow the instructions on the color match silicone sealant
tube.
m When job is complete, inspect all caulked areas for gaps
and fill as needed.
m Clean up any excess silicone using denatured alcohol and a
clean cloth.
m Be very careful not to disturb caulk joints.
Swan 6 800-325-7008
General Information Installation Procedure