Installation & Assembly

Wall Kits With
Separate Corner
Panels - TF-57,
TI-5, and TI-7260
TI-5
TF-57
TI-7260
Note: Faux tile wall
kit installation shown.
Smooth finish wall kit
installation is the same.
Corner Panels
Many corner panels are
designed to be installed
a certain way. Check
for identification tags on
the back of the panels.
Molded in shelves must
be installed with the flat
surface facing up.
1. Select either a left or
right corner panel. Trial fit the corner panel, and make
any necessary adjustments.
Note: Corner shower wall kits only have one corner panel.
Install it with the flat surface of the molded in shelf facing up.
IMPORTANT NOTICE
Model TI-7236, TI-7248, and TI-7260 Shower Wall Kits. The
sides of the corner panels are different widths. One side is 5
inches wide and the other is 7 inches wide. The orientation of
the corner panel will affect the allowable width of the wall
dimensions. Refer to the illustration and chart for proper
orientation.
7”
34”
or less
BACK WALL
SIDE
WALL
5”
7”
Over 34”
BACK WALL
SIDE
WALL
5”
Corner Panel with 7 Inch Dimension on Enclosure Back Wall
Side Panel Fits 31 to 34 inch Side Wall
TI-7260 Back Panel Fits 53-1/4 to 63-3/4 inch Back Wall
Corner Panel with 5 Inch Dimension on Enclosure Back Wall
Side Panel Fits 31 to 36 inch Side Wall
TI-7260 Back Panel Fits 53-1/4 to
59-3/4 inch Back Wall
WARNING
Fumes Hazard
The fumes from the silicone sealant and solvents used by the
installer can be harmful if used in an unventilated room.
Always work in a well-ventilated area. To keep the area well-
ventilated, open windows and use exhaust fans. If adequate
ventilation is not achievable or practical, use respiratory
protective equipment.
2. Clean the back of the panel with denatured alcohol.
IMPORTANT NOTICE
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the panel
from properly adhering to the wall.
3. Apply the silicone sealant in 1-1/4 inch diameter dots
every 8 to 10 inches over the back surface of the panel.
Follow the silicone manufacturer’s instructions and note all
ventilation and installation precautions.
800-325-7008 9 Swan
Installation Procedure