MSDS

MATERIAL SAFETY DATA SHEET
PREMIER INDUSTRIAL SUPPLY, INC.
Page 2 of 8
Version: 1.1
Revision Date: March 3, 2011
XTRABOND XB250 ACETOXY CURE SILICONE SEALANT
2
Medical Conditions Aggravated by Exposure
No known applicable information.
The above listed potential effects of overexposure are based on actual data, results of studies performed upon similar compositions, component data and/or
expert review of the product. Please refer to Section 11 for the detailed toxicology information.
3. COMPOSITION/INFORMATION ON INGREDIENTS
CAS Number Wt % Component Name
64742-46-7 5.0 - 10.0 Hydrotreated middle petroleum distillates
17689-77-9 1.0 - 5.0 Ethyltriacetoxysilane
4253-34-3 1.0 - 5.0 Methyltriacetoxysilane
The above components are hazardous as defined in 29 CFR 1910.1200.
4. FIRST AID MEASURES
Eye: Immediately flush the contaminated eye(s) with lukewarm, gently flowing water for 15 – 20
minutes while holding the eyelid(s) open. If contact lens is present, DO NOT delay irrigation or
attempt to remove the lens. Take care not to rinse contaminated water into the unaffected eye
or onto the face. Immediately obtain medical attention.
Skin: Remove contaminated clothing, shoes and leather goods (e.g. watchbands, belts). Quickly
and gently blot or brush away excess chemical. Flush with lukewarm gently flowing water for
15 minutes. If irritation persists, repeat flushing. If irritation persists, obtain medical advice.
Inhalation: Material is not likely to present an inhalation hazard at ambient conditions. If material is heated
or vapor is generated, care should be taken to prevent inhalation. In case of exposure to
vapor, move to fresh air.
Oral: If irritation or discomfort occur, obtain medical advice.
Note to Physician: Treat according to person's condition and specifics of exposure.
5. FIRE FIGHTING MEASURES
Flash Point: > 212 °F / > 100 °C (Closed Cup)
Autoignition Temperature: Not determined.
Flammability Limits in Air: Not determined.
Extinguishing Media: On large fires use dry chemical, foam or water spray. On small fires use carbon dioxide (CO2),
dry chemical or water spray. Water can be used to cool fire exposed containers.