Instruction manual

13
Problems
Iron won’t heat
Droplets of water
escape from the
soleplate
Water tank
decoration indicator
light OFF
All indicator light
OFF
Iron does not
produce steam
Water tank
light blinks. Two
BEEP sounds alarm
when pressing
the steam button.
Possible causes
Incorrect connection to the
main socket
Re-plug the unit to main socket.
Temperature setting knob is
set at O position.
Set to the required position.
Power OFF
Switch the appliance ON
Handle has not been laid down
Lay handle down
Steam is set at higher position.
Set to lower steam setting.
Filter is missed to install
Install the filter
Unknown malfunction.
Take it to qualified service man
or manufacturer for repair.
No water or not enough water
in water tank.
Fill water to water tank as
described in “Fill water tank”.
Water tank has not been
installed in place.
Well install the water tank
Un-known malfunctions
Take it to qualified service man
or manufacturer for repair.
The appliance comes into
auto-shut off mode.
The set temperature has not
been reached.
Press power ON/OFF to reset it.
Allow sufficient time to preheat
until heating indicator light turn
off.
Steam button is not set at
steam ironing position.
Ensure the steam button is set
at steam ironing position and
steam indicator light is ON.
Temperature control dial is set
at low temperature position.
Set temperature setting knob to
suitable position refer to Fabric
setting chart.
The set temperature has not
been reached or is too low.
Allow sufficient time for iron to
preheat or set higher
temperature.
Solution
Trouble shooting