BATHTUB WALL PANELS Installation Care and Cleaning Model No. SS-60 Owner’s Manual CAUTION: Patent Pending Read ALL instructions carefully BEFORE starting your installation.
BATHTUB WALL PANELS Step-By-Step Installation Instructions Model SS-60 Designed To Fit 30⬙ x 60⬙ Bathtub INCLUDED IN CARTON: A Four flat panels B One center panel with two molded-in soap and shampoo shelves C Two corner moldings D One foam spacer E One tube color coordinated caulk F Three tubes of adhesive TOOLS REQUIRED TO INSTALL The only tools needed are a saber saw or drill, ruler, caulking gun, and whatever tools are needed to remove faucet handles. Panels mount to the wall with supplied adhesive.
WALL SURFACE PREPARATION RECOMMENDATIONS FOR SWANSTONE TUBWAL AND SHOWERWAL UNITS When installing over SHEETROCK/GREENBOARD/WOOD: A) Surface must be dry, smooth and free of any dust, soap scum or any other contaminants. Wipe wall surface with a damp cloth. B) For maximum adhesion, the area where the double-faced tape adheres to the wall surface should be sealed with a primer (Bin-Seal or all purpose enamel paint).
IMPORTANT USE ROUTER, SPADE BITS, TWIST DRILL OR HOLE SAWS ONLY. DO NOT USE AUGER BITS. 6. SIDE WALLS If the end of the tub has settled or the walls are out of plumb, it may be necessary to cut the bottom edge of a panel(s) to achieve a good fit across the top. Measure location of plumbing outlets from back wall forward and from the top ledge of the tub upward. Then mark the position onto side panel. 9.