Installation Guide

16. Once the adhesive has cured, remove the clamps.
Use the Swanstone Part # VW 0050-000 special
countersink drill bit and drill pilot holes in the
remaining sink rim screw locations. Install the
appropriate screw in each of the holes and tighten
securely.
Sink Cut-Out
With the sink secured to the underside of the countertop,
the opening for the under mount sink can be cut and
machined.
Before cutting the starter hole in the vanity top, make
sure the hole location will not cause the hole saw to
damage the sink bonded to the underside of the vanity
top. To avoid damage to the sink, locate the opening
towards the center of the sink.
1. Place the sink and countertop on a secure work
surface. Use a 1 inch to 2 inch diameter tungsten
carbide tipped hole saw to cut an opening in the
center of the vanity top, as shown.
2. Install the Swanstone part # VW 10030-001 bit with
roller bearing into the router.
IMPORTANT NOTICE
800-325-7008 9 The Swan Corporation
Installation