Quick Start Guide

7
EN
INSTALLATION INSTRUCTIONS
IMPORTANT! TURN POWER OFF AT CIRCUIT BREAKER OR FUSE BOX.
CAUTION: BEFORE HANDLING ANY WIRING, USE A CIRCUIT TESTER TO CONFIRM THAT POWER IS OFF.
When installing the unit, refer to the installation diagram on the previous page.
1 If you're replacing an old floodlight unit, disassemble it along with any existing mounting
bracket from the junction box and disconnect the wire connections.
2 The floodlight camera unit's mounting bracket comes pre-assembled. Remove both the screw
cap and the mounting bracket screw
A
to separate the mounting bracket.
3 Fix the mounting strap (supplied) to the junction box using two mounting screws
B
(three sets
of different screw types supplied) that best fit your junction box. The side of the mounting strap
marked "FRONT" should be facing out.
4 Connect the junction box and floodlight wires using the wire nuts (supplied). Use the color code
of the wires to match correct connections, as shown in the installation diagram.
5 Once the wires are connected, carefully tuck them into the junction box.
The floodlight camera unit is designed to be mounted on a standard wiring junction box and requires
connection to a 100-240VAC power supply. For optimum results, install the unit at least 8 feet (2.4m)
above the ground.
NOTE: BEFORE MOUNTING, ENSURE THE INSTALLATION LOCATION IS WITHIN RANGE OF YOUR CURRENT WI-FI SIGNAL.
SEE "GETTING STARTED" ON PAGES 4-5 FOR INFORMATION ON HOW TO CHECK WI-FI COVERAGE.
(continued next page)