Quick Start Guide

INSTALLATION INSTRUCTIONS

6 Position the mounting bracket on the junction box, insert the mounting bracket screw

with

washer

through the mounting bracket hole into the center hole of the mounting strap and

tighten the mounting bracket screw to secure in place.

7 Re-attach the floodlight camera unit to the mounting bracket with the previously removed

mounting screw

. Then insert the screw cap firmly into the mounting screw hole.

8 It is recommended that silicone sealant (not supplied) be applied around the edge of the

mounting bracket (between the bracket and the surface) to prevent moisture from entering the

junction box.

9 Restore power at the circuit breaker/fuse box and allow the floodlight camera unit to power

up. This can take up to 2 minutes. During power-up, the floodlights will turn on for a brief

moment.

CAUTION: Floodlights are extremely bright. To avoid possible damage to your eyes, do not

stare directly at the floodlights when they are on.

10 Once you hear the camera say “Ready for pairing” and the LED indicator starts blinking blue

slowly, proceed to the Swann Security app to set up the camera with your Wi-Fi network and

link it to your Swann Security account.