Instruction Manual

BATTERY INSTALLATION

Indoor Alarm Receiver

The Indoor Alarm Receiver requires 3 AA batteries (not supplied) to operate.

For reliable, long-lasting performance, use only high quality alkaline batteries.

To install batteries:

1. Push the release tab and lift off the battery compartment cover.

2. Insert 3 new AA batteries, matching the polarity markings (+ and -) shown inside the

battery compartment.

3. Replace the battery compartment cover.

Alert Sensor

The Alert Sensor requires 3 AAA batteries (not supplied) to operate.

For reliable, long-lasting performance, use only high quality alkaline batteries.

To install batteries:

1. Using a small Phillips

screwdriver, remove the two screws securing the battery

compartment cover, and then lift off the cover.

2. Insert 3 new AAA batteries, matching the polarity markings (+ and –) shown inside

the battery compartment.

3. Replace the battery compartment cover and screw it back into place with the

previously removed screws.

Doorbell

WARNING! This product contains a button/coin cell battery. If the button/coin cell battery is swallowed,

it can cause internal chemical burns in as little as two hours and lead to death. Dispose of used

batteries immediately. Keep new and used batteries away from children. If the battery compartment

does not close securely, stop using the product. If you think batteries might have been swallowed or

placed inside any part of the body, seek immediate medical attention.

Australia: If you think batteries might have been swallowed or placed inside any part of the body,

immediately call the 24-hour Poisons Information Centre on 13 11 26 for fast, expert advice and go

straight to the nearest hospital emergency room.

The Doorbell is powered by a CR2025 battery (supplied).

To install the battery:

1. Using a small Phillips

screwdriver, remove the screw securing the battery

compartment cover.

2. Rotate the battery compartment cover counter-clockwise until the arrow aligns

with the Unlock position and lift off the cover.

3. Place the new CR2025 battery in the battery compartment with the positive (+) side

facing up.

4. Replace the battery compartment cover rotating clockwise until the arrow aligns

with the Lock position and fasten with the previously removed screw.