Instruction Manual

OPERATING BASICS

Pairing the Alert Sensor with the Indoor Alarm Receiver

1. Place the Alert Sensor faced down to avoid triggering it.

2. Decide which Sensor Channel (1, 2 or 3) you want to assign to the Alert Sensor,

then press and hold the desired Sensor Channel Number button on the side of the

Indoor Alarm Receiver until the corresponding Sensor Channel LED indicator lights

up and a beep is heard. The Indoor Alarm Receiver is now in pairing mode.

3. Within 25 seconds, trigger the Alert Sensor by lifting it up. The Sensor Channel

melody sounds with the corresponding Sensor Channel LED indicator blinking on

the Indoor Alarm Receiver to conrm successful pairing.

Note: You can also pair the Alert Sensor by pressing the CODE button inside the

battery compartment of the Alert Sensor.

4. If pairing is not completed within 25 seconds, the Sensor Channel LED indicator

goes off and the Indoor Alarm Receiver is no longer in pairing mode. Repeat the

steps above to pair the Alert Sensor again.

Pairing the Doorbell with the Indoor Alarm Receiver

1. Press and hold the Doorbell Channel button on the side of the Indoor Alarm

Receiver until the Doorbell Channel LED indicator lights up. The Indoor Alarm

Receiver is now in pairing mode.

2. Within 25 seconds, press the Doorbell button. The Doorbell Channel melody sounds

with the Doorbell Channel LED indicator blinking on the Indoor Alarm Receiver to

conrm successful pairing.

3. If pairing is not completed within 25 seconds, the Doorbell Channel LED indicator

goes off and the Indoor Alarm Receiver is no longer in pairing mode. Repeat steps

above to pair the Doorbell again.

Adjusting the Indoor Alarm Receiver Volume

There are three volume levels available. Simply press the Volume button on the side of

the Indoor Alarm Receiver until the desired volume level is obtained. You will hear the

difference in volume each time the Volume button is pressed.

TIP: The Doorbell can also be paired with one of the Sensor Channels, if desired. In step

1 above, press and hold any Sensor Channel Number button (instead of the Doorbell

Channel button) until the Sensor Channel LED indicator lights up.

TIP: The Alert Sensor can also be paired with the Doorbell Channel, if desired. In step

2 above, press and hold the Doorbell Channel button (instead of the Sensor Channel

Number button) until the Doorbell Channel LED indicator lights up.