READ ME FIRST DIY WIRELESS ALERT Add-on Alert Sensor For Swann Wireless Alert systems EN Instruction Manual
About this Manual The content in this manual is for information purposes only and is subject to change without notice. While every effort is made to ensure that this manual is accurate and complete at the time of printing, no liability is assumed for any errors and omissions that may have occurred. As we’re constantly making improvements to our products, firmware, software and user manuals, we reserve the right to change the information without prior notice.
Battery Safety Information Replace batteries at the same time. Do not mix new and old batteries or battery types (for example, alkaline and lithium batteries). Keep batteries out of reach of children. Dispose of used batteries promptly in accordance with local regulations. Limited Warranty Terms & Conditions Swann Communications warrants this product against defects in workmanship and material for a period of one (1) year from it’s original purchase date.
At a Glance Thank you for choosing the Add-on Alert Sensor. It's the ideal addition to your Swann Wireless Alert system. Please take a moment to familiarize yourself with key parts of your Alert Sensor. Status LED Groove Passive Infrared Motion Detector Battery compartment Installing batteries The Alert Sensor requires 3 x AAA batteries (not included) to operate. To install batteries: 4 1.
Pairing with the receiver Assign your Alert Sensor to one of the 3 channels (each with distinct audible sound) available on the Indoor Alarm Receiver. 1. Place the Alert Sensor faced down to avoid triggering it. 2. Decide which sensor channel (1, 2 or 3) you want to assign your sensor to, and then press and hold the desired Sensor Channel button on the back of the Indoor Alarm Receiver until the LED indicator for that channel lights up. 3. Within 10 seconds, trigger the Alert Sensor by lifting it up.
Adjusting the alarm volume You can change the loudness of the Indoor Alarm Receiver using the Volume button on the back of the receiver. Three volume levels are available: High, Medium and Low. Silent mode Like some peace and quiet for a period of time? You can put the alarm triggered by the Alert Sensor on “silent”. Simply press the Channel button that corresponds with the Alert Sensor that you want the alarm muted. The Indoor Alarm Receiver beeps twice, confirming the alarm has been turned off.
Placement guide The Alert Sensor, under typical conditions, is designed to detect people and vehicles moving within an area of approximately 12 meters (around 40 feet) at a 100° angle from the sensor. 2m /6ft 100° 12m/40ft (under typical conditions) Ideal approach path (greatest sensitivity) For best coverage and to maximize detection, mount the Alert Sensor approximately 2 meters /6 feet off the ground, pointing on a slightly downwards angle.
Helpdesk / Technical Support Details Swann Technical Support All Countries E-mail: tech@swann.
