User Manual

34
Location of Reset button
Pairing the Device - Wi-Fi Floodlight Security Camera
(Continued on the next page)
Check if the LED indicator on your camera is
blinking blue slowly as shown. If so, your camera is
already in pairing mode (i.e., the camera's hotspot
is activated temporarily) and ready to pair. Tap the
Next button.
NOTE
If your camera is not in pairing mode (LED is not
blinking blue slowly)
Press and hold the Reset button on back of the
camera (as shown below; remove flap to access
button) for 5 seconds until the LED indicator
starts blinking blue rapidly, and wait for about 30
seconds. When the LED indicator starts blinking
blue slowly, your camera is in pairing mode.
Tap the Start button to allow the app to
automatically connect to the camera's hotspot (e.g.,
Swann-SWIFI-xxxxxx) and pair your camera to your
home Wi-Fi as well as link to your Swann Security
account.
NOTE
If, for any reason, the app fails to connect
automatically to the camera's hotspot, you can
manually connect to the camera's hotspot:
Go to the Wi-Fi settings on your phone and connect
to the camera's hotspot (e.g., Swann-SWIFI-xxxxxx).
Then, return to the app and tap the Retry button to
continue setup.