User Manual

Click for contents

Network: Network

PPPoE: Allows your DVR to be directly connected to a DSL modem. When

selecting this option, you need to input the user name, password and DNS

settings for your internet service provider.

DHCP (Dynamic Host Configuration Protocol): Your router will automatically

assign an IP address to each device connected to your network. This is ena-

bled by default.

Static: All devices on your network have their IP address manually defined.

Client Port: This port number is used by your DVR to send information

through. The default number will work in most situations.

HTTP Port: This port number is used to log into your DVR from a remote lo-

cation. The default number will work in most situations.

The following five options can be changed when selecting Static:

IP Address: Each device on your network must have a unique IP address. A

typical address might be “192.168.1.24” or something similar.

Subnet Mask: This allows the flow of network traffic between hosts to be

segregated based on a network configuration. A typical address might be

“255.255.255.0” or something similar.

Gateway: This allows your DVR to connect to the internet. This is typically the

same IP address as your modem or router.

DNS (Domain Name System)1/2: Input the DNS settings for your internet

service provider.

(continued on next page)

As SwannLink Peer-to-Peer

technology is utilised to com-

municate with your network

and mobile device, config-

uration of the network set-

tings is not required. If you

have networking expertise

and require specific settings

for your network, you do have

the ability to change them.

· Don’t forget to click “Save”

to apply settings.

· Click the “Default” button to

revert back to default settings.

· Click the “Close” button to

exit the Main Menu.