User Manual

Click for contents
16
Channel: Adding a Camera in Station Mode
It’s recommended that you add cameras to your NVR when it’s in AP mode
(see page 15 - Channel: Adding a Camera in AP Mode) before changing to
Station mode.
1. When all cameras have been added to your NVR, for Wi-Fi Mode click the
drop down menu and select “Station” (as shown above).
2. After a short moment, a list of Wi-Fi access points that your NVR detects,
will be shown. Select your Wi-Fi access point then click the next button (circle
& triangle).
3. Input the password for your Wi-Fi access point then click the next button
(circle & triangle). Make sure the password is correct before proceeding.
4. A message will appear on-screen stating that all cameras must be con-
nected before proceeding. Click the next button (circle & triangle).
5. The cameras connected to your NVR will be displayed. A tick icon will ap-
pear in each checkbox. If one or more cameras haven’t appeared, click the
“Refresh” button otherwise click the “Apply” button.
6. After a brief moment your NVR will reboot then you will see your cameras
in Live View mode. You can now disconnect the Ethernet cable connected to
your NVR’s Ethernet port.