User Manual

Click for contents
37
System: Maintenance
Enable auto reboot: It’s recommended to leave this enabled as it maintains
the operational integrity of your NVR.
Auto reboot at: Choose an appropriate day and time to reboot your NVR.
Upgrade From Local: Click this to upgrade the firmware via a USB flash
drive. Select the firmware file, click “Upgrade” then “OK” to confirm. When
the firmware upgrade has completed, your NVR will reboot automatically.
Upgrade From Cloud: Click this to check if an updated firmware is available
using your internet connection. A message will appear on-screen informing
you if an update is available. Click the “Upgrade” button to proceed then fol-
low the on-screen instructions.
Upgrade Camera from USB: Click this to upgrade the camera’s firmware
via a USB flash drive (see above right screenshot). To upgrade the firmware,
click “Browse”, select the firmware file then click “OK”. Repeat these steps
for each camera displayed. When finished click “Upgrade”. Each camera will
restart when the upgrade has completed.
Default Settings: Click this to restore factory default settings. All recordings
on the storage device will remain.
→ Click the “Default” button to revert back to default settings.
→ Don’t forget to click “Apply” to save settings.