Operating instructions

15
Removing a Preset Point
Removing Preset Points is performed in much the same manner as defining them.
Once a Preset Point has been removed, selecting it as detailed opposite will no
longer have any effect, until a new point is set.
Press the DELETE button on the remote, and hold for two seconds.•
The display will now read “Clr-”•
Press a number key to select a Preset Point number. To choose a Preset Point •
with a value higher than 10, press the -/-- button first.
Press ENTER to confirm.•
The selected Preset Point will now no longer be set.•
Cruise Mode
Whilst the PRO-650 is in Cruise Mode, the camera will move continuously and
automatically, only pausing when it arrives at Preset Points for a short interval.
There are two ways to enter Cruise mode.
Auto-scan (Cruise) Mode
When in Auto-scan Mode, the PRO-650 will continuously move automatically,
attempting to observe as much of the field of view as practicable in the shortest
time it can.
To enter Auto-scan Mode, press AUTO.•
For an alternate Auto-scan mode, go to Preset Point 99.•
Manual Cruise Mode
You can program lists of Preset Points for the PRO-650 to view in order.
First, create all the Preset Points you wish to see, as detailed on page 8.•
Press and hold PATTERN for two seconds. •
The display will now read “PStA”.•
Press the NUMBER button for the first Preset Point you want in the programmed •
loop, using the -/-- button to access points higher than 10 if necessary.
Press ENTER once the camera has moved to that Preset Point to confirm.•
Repeat for the other Preset Points you want on the loop, in the order that you •
want them to be accessed. Remember to press ENTER each time to confirm
your selection.
Press and hold PATTERN for two seconds. The display will now show “PSt0” •
confirming that the pattern programming has ended and the pattern has been
saved.
Press RUN to initiate the programmed pattern, and press RUN again to stop •
the pattern.
To reset the Cruise Mode settings to their default values, press PRESET followed •
by -/--, and enter “240”.