Installation Instruction Manual

7. Temporarily secure the soap dish with masking tape,

as shown. Remove tape after approximately two

hours. Do not place anything on the soap dish for at

least 24 hours.

Corner Molding (Optional)

Installing the corner molding is optional. If the panels

were scribed and cut to create a tight-fitting corner, then

the corner molding can be eliminated. If, however, there

are gaps between the front/rear panel, the corner

molding should be installed. Either option, if done

properly, is acceptable.

If the optional soap dish was installed, cut one piece of

molding to fit above the soap dish and one for below the

soap dish.

NOTE: The silicone adhesive required for the

installation of the corner molding is the same as used for

the installation of the Swanstone wall panels. This kit

contains enough adhesive for both the wall panels and

the corner molding.

1. Measure and cut the corner moldings to length. If

the optional soap dish was installed, cut one piece

of molding to fit above the soap dish and one for

below the soap dish.

2. Dry fit the corner molding.

001c

005

The Swan Corporation – Swanstone 26 800-325-7008

Installation Procedure