Installation Instruction Manual

The fumes from the sealants and
solvents used by the installer can be
harmful if used in an unventilated room.
Always work in a well-ventilated area.
3. Clean the surface of the panels and the back of the
molding with denatured alcohol or another non-oil
based solvent.
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the
panel from adhering properly to the wall.
4. Apply a 1/8 to 1/4” bead of silicone to the back of
the corner molding in an S pattern, as shown.
5. Press the corner molding into place. Remove any
excess silicone.
6. Place at least three pieces of masking tape on each
corner molding to hold it in place until the silicone
adheres to the wall panel.
BK
-
CM
-
005c
IMPORTANT NOTICE
WARNING
800-325-7008 27 The Swan Corporation – Swanstone
Installation Procedure