Installation Guide

5. Fixture hole locations are
identified with a gray label
indicating the most desired
placement. Position a chisel on
the desired dot and strike with
a hammer to break out the
hole. Clean out fixture hole
with a knife.
If hole is not used, peel off the
label.
Attach faucet, drain, and
accessories according to man-
ufacturer’s instructions.
6. Apply a bead of caulk (not
included) to the underside of
the sink flange and position
sink into counter top opening.
7. Attach four (4) sink clips to
underside of sink. Sink clips
provided will accommodate a
counter top up to 1-1/2⬙ thick.
Tighten screws in front then
rear first. Work from side to
side. Do not overtighten. Clean
up excess caulk.
8. Connect all faucet supply
lines, disposal (if available),
and drain trap fittings per
manufacturer instructions.
CHECK FOR LEAKS
• Supply user tubes to faucet
• Supply riser tubes to shut off
valves or lower connections
• Fill sink with water and check
for leaks around drain
• Release water from sink and
check for possible leaks
• Tighten as needed
BAR SINKS
CLEANING
Clean your Swanstone sink as
you would any other fine bath
fixture, using normal house-
hold detergents and cleansers.
Just wiping the wall surfaces
quickly removes watermarks
and residues. Occasional
scrubbing with household
abrasive cleansers ensures
that the original luster is
maintained.
REPAIRING
SOLID COLORS
Use 400 grit sandpaper to
remove scratches and gouges
in the surface. A “scotchbright
pad” can be used to blend in
the area.
AGGREGATE & GALAXY
COLORS
Use 400 grit sandpaper to
remove scratches and gouges
in the surface. To blend in the
area use a fine grade, white,
automotive polishing com-
pound or paste wax.
Patent Pending
Form #256-11-91-10M
The Swan Corporation
One City Centre
St. Louis, MO 63101
[phone]
APPLY CAULK