Installation Guide

Soap Dish Installation (Optional)
The soap dish is a corner mount design. The soap
dishes can be stacked in one corner or placed in
opposite corners.
Note: The current production soap dish is molded with a
square corner (as shown in the illustrations). This shape
requires installation of the optional corner molding after
installation of the soap dish. If your kit contains a sculpted
corner soap dish, the optional corner molding should be
installed before the soap dish. When the current stock of
sculpted corner soap dishes is exhausted, this design will
no longer be available.
Installation of Square Corner Soap Dish
1. Select a desirable height for mounting one or both
soap dishes. A height of at least 43” from the
shower floor to the soap dish is recommended.
2. After marking the height, draw a 4” level-line on both
walls. These lines will be used to align the top
edges of the soap dish.
3. Dry fit the soap dish prior to applying silicone. If the
wall is not exactly 90 degrees square, it will be
necessary to sand the sides of the soap dish in
order to achieve proper fit, using a course grit
(60 grit) sandpaper.
4. Apply silicone to the edge of the soap dish.
43"
The Swan Corporation – Swanstone 18 800-325-7008
Installation Procedure