Installation Guide

The Swan Corporation One City Centr
e Suite 2300 St. Louis, MO
63101 800-325-7008
1. Invert sink and position onto
the countertop. Locate sink front
to rear and right to left so the
bowl will not interfere with the
cabinets below. Trace a pencil
line around the outside edge of
the sink and remove the sink from
the countertop. Measure in 5/16"
(8mm) from the initial sink outline
and draw a second line inside the
first. Draw a 1-1/2" radius at
each corner. The second interior
line will be your cut out line.
2. Drill starter hole inside of cutout
line.
3. Using a saber saw, cut inside of
cutout line. Trial fit sink to check
proper fit.
4. Identify fixture hole locations.
Drill a starter hole from reverse
side. Working from the top side as
illustrated, position a hole saw on
the starter hole and drill to com-
plete the fixture hole. Attach
faucet, drain, and accessories
according to manufacturer’s
instructions.
5. For final fit, apply a bead of
caulk (not included) to the under-
side of the sink flange and position
sink into countertop opening. First,
tighten screws in front, then tight-
en rear screws.
6. Connect all faucet supply lines,
disposal (if available), and drain
trap fittings per manufacturer’s
instructions.
CHECK FOR LEAKS:
• Supply user tubes to faucet
• Supply riser tubes to shut off
valves or lower connections
• Fill sink with water and check
for leaks around drain
• Release water from sink and
check for possible leaks
• Tighten as needed
Care and Cleaning Instructions
NOTE: This procedure does not apply to the Gloss Finish models.
Clean your Swanstone kitchen sink with powdered abrasive cleaners. Use
of a Scotch Brite pad is recommended to remove stubborn stains.
Occasional use of a mild bleach and water solution ensures that the
original luster is maintained.
DEPTH 8” (203mm)
DEPTH 8” (203mm)
Care and Cleaning Instructions for
Gloss Finish Models KSGF-2522 and KSGF-3322
WARNING: DO NOT USE ABRASIVES AS IT WILL DULL THE GLOSSY FINISH!
This product is made of Swanstone with a gloss finish. While it is stain resistant, it
r
equires regular and reasonable care. Wash regularly with warm water and a non
abrasive cleaner such as Soft Scrub Liquid Gel with bleach (without abrasives), Clorox
Clean-up with bleach, Top Job or Mr. Clean. Remove hard water stains or mineral
build up with scale removers such as Lime-Away.
DO NOT USE HARSH CLEANSERS OR ABRASIVES such as scouring powders,
abrasive cleansers or scouring pads. Abrasives will dull the finish. Pr
otect the finish
with fiberglass wax or automotive paste wax.
Model KSGF-3322
33” x 22” (838mm x 559mm)
Model KSGF-2522
25” x 22” (635mm x 559mm)
A
B
D
A
B
C
Gloss Finish Models
Drop-In Kitchen Sink
Installation Instructions
Form #195-11-06