Dimensions Guide

The Swan Corporation ❚ One City Centre Ste. 2300 ❚ St. Louis, MO 63101 ❚ p [phone] ❚ f [phone] ❚ www.swanstone.com
101
T U B & S H OW E R
M A I N T E N A N C E A N D
C L E A N I N G I N F O R M AT I O N
Everyday cleaning should consist of liquid
cleaners such as Dow or Lysol foaming
bubbles, Top Job, Mr. Clean or liquid Lysol
along with a sponge. Remove hard water
stains, mineral or soap build-up with scale
removers such as Lime-Away. If necessary,
you may use an abrasive cleaner such as
Ajax or Comet with a nylon brush or pad
to remove build up on the pebble surface.
Do not use steel wool or a wire brush.
An abrasive cleaner, brush or pad will
not remove the finish because the color
is molded throughout. However, it is best
to avoid the higher sheen surface of the
floor. Prolonged scrubbing of this area
could cause it to look dull and promote
soap build up.
Single Threshold Shower Floors
With Fit-Flo Drain
Veritek
®
SHOWER FLOORS
WARRANTY
Limited Lifetime – Residential
Limited 5-year – Commercial
Manufactured from Swanstone Veritek
®
(see page 2 for detailed information)
S P E C I F I C AT I O N S
Single Threshold Shower Floors With Fit-Flo Drain
Ship Ship Carton
Model Part Nominal Size Dimensions Wt. Lb. UPS Dims. In. Cu. Ft.
R-3232 FF03232MD 32" D x 32" W (813 mm x 813 mm) 32 – 38 x 37 x 10 9
R-3248 FF03248MD 32" D x 48" W (813 mm x 1219 mm) 49 – 54 x 38 x 10 12
R-3260 FF03260MD 32" D x 60" W (813 mm x 1524 mm) - Center drain 56 – 66 x 37 x 10 15
R-3442 FF03442MD 34" D x 42" W (864 mm x 1067 mm) 46 – 48 x 40 x 10 12
R-3448 FF03448MD 34" D x 48" W (864 mm x 1219 mm) 47 – 54 x 39 x 10 13
R-3454 FF03454MD 34" D x 54" W (864 mm x 1372 mm) 55 – 60 x 40 x 10 14
R-3460 FF03460MD 34" D x 60" W (864 mm x 1524 mm) 63 – 66 x 40 x 10 16
R-3636 FF03636MD 36" D x 36" W (914 mm x 914 mm) 40 – 42 x 41 x 10 10
R-4236 FF04236MD 42" D x 36" W (1067 mm x 914 mm) 44 – 47 x 42 x 10 12
R-4242 FF04242MD 42" D x 42" W (1067 mm x 1067 mm) 53 – 48 x 48 x 10 14
Kit Includes: One code approved compression molded Veritek
®
shower
floor with molded-in Fit-Flo drain and complete installation instructions.
Packaging: Each floor packed in a rectangular carton.
• White (010) • Bone (037) • Bisque (018)
C O L O R S
(See pg. 139 for color sample.)
S U P P O R T D O C U M E N T S
Installation instructions available on line at www.swanstone.com
S TA N D A R D S A N D R AT I N G S
Class B fire rating
American National Standard Institute—ANSI Z124.1.2–2005
International Association of Plumbing and Mechanical Officials (IAPMO)—listed
cUPC listed—Certified to CSA Standard B45 by IAPMO
American Society for Testing and Materials
National Electrical Manufacturers Association
Nominal Rough-In Dimensions
Model Size A B C D
R-3232 32" x 32" 32-3/8" 32-3/16" 16-3/16" 16-3/16"
R-3248 32" x 48" 48-3/8" 32-3/16" 24-3/16" 16-3/16"
R-3260 32" x 60" 60-3/8" 32-3/16" 30-3/16" 16-3/16"
R-3442 34" x 42" 42-3/8" 34-3/16" 21-3/16" 17-3/16"
R-3448 34" x 48" 48-3/8" 34-3/16" 24-3/16" 17-3/16"
R-3454 34" x 54" 54-3/8" 34-3/16" 27-3/16" 17-3/16"
R-3460 34" x 60" 60-3/8" 34-3/16" 30-3/16" 17-3/16"
R-3636 36" x 36" 36-3/8" 36-3/16" 18-3/16" 18-3/16"
R-4236 42" x 36" 36-3/8" 42-3/16" 18-3/16" 20-3/16"
R-4242 42" x 42" 42-3/8" 42-3/16" 21-3/16" 21-3/16"
F E AT U R E S
• Will not mold or mildew, no grout to clean
• Coordinates with Swanstone shower and bath walls, vanity
tops and wainscoting
• Pebbled, slip-resistant surface
• Made of Veritek with no surface coating to chip or crack
IMPORTANT: Rough-in
dimensions are provided
for reference only. You must
measure the actual shower
floor and check local building
code requirements before
construction of the stud wall.
Model A B C D
R-3232 32" 32" 16" 16"
R-3248 48" 32" 24" 16"
R-3260 60" 32" 30" 16"
R-3442 42" 34" 21" 17"
R-3448 48" 34" 24" 17"
R-3454 54" 34" 27" 17"
R-3460 60" 34" 30" 17"
R-3636 36" 36" 18" 18"
R-4236 36" 42" 18" 20"
R-4242 42" 42" 21" 21"