Veritek TM Natural Gloss Composite Model No.’s SA-3232 SA-3636 SA-3448 SA-38NEO Owners Manual Shower Alcove Walls Caution: Read ALL instructions carefully BEFORE starting your installation. Save this manual for future reference.
Veritek TM Natural Gloss Composite Step-By-Step Installation Instructions Model No.’s SA-3232 SA-3636 SA-3448 SA-38NEO Shower Alcove Walls 11⁄4” II 29” I Back Panel Back Panel Dimensions SA-3232 SA-3636 SA-3448 I 32” I 36” I 48” II 3” II 7” II 5” 72” Veritek Natural Gloss Composite Shower Alcove Walls B A SA-3232: Fits shower floor size 32” deep, 32” wide; wall size 32” wide, 32” deep, 72” installed height.
Preparation Important: Before you begin, remove the shower floor and wall system from the protective cartons and inspect them for damage. Also, check against figure #1 or #2 to ensure all installation materials are included in package. NEVER install shower floor over open floor joists. Shower floor must be installed on solid, level subfloor. This shower may be installed over any surface during any stage of construction.
Veritek TM Natural Gloss Composite Shower Alcove Walls Read the following step-by-step installation procedures before you begin. Shower Alcove Wall Installation Set the back or corner panel into place so that it sets firmly down onto the back ledge of the shower floor. So that you may proceed to the next step, it is a good idea to temporarily secure the back or corner panel with a bent nail over the flange.