MODEL NO. SD-36 NEO SD-38 NEO SD-A38 NEO CAUTION Read ALL instructions carefully BEFORE starting your installation. Save this manual for future reference.
STEP-BY-STEP INSTALLATION INSTRUCTIONS FOR NEO ANGLE PIVOT SHOWER ENCLOSURE Inventory all shower door parts. Be sure you have purchased the correct shower door for the proper Swanstone shower floor size. H K The shower door is designed to install over a Swanstone shower floor. Under normal installation, NO CUTTING WILL BE REQUIRED. A F Tools Required G • • • • • • B C I Ruler & Pencil Level Screwdriver (phillips head) Electric Drill 1/8” and 1/4” Drill Bit Tube of Caulk Neo A. B. C. D. E. F.
INSTALLATION PROCEDURE 1. The Swanstone Neo-Angle Pivot Shower Door is reversible and may be installed to pivotleft or pivot-right (hinge -left or hinge -right). For maximum waterproofing, the pivot jamb should be opposite the shower head. Use the above diagram to determine the correct position for the door. The following installation instructions illustrate a pivot-right installation. 2. Measure and mark the center line of the shower sill. Place the wall jambs against the wall centered in the sill.
5. Position the pivot side of the door frame to the side panel. Working from the bottom up, rotate the door frame until the snaps fasten. Snap the strike side of the door frame to the other side panel while making sure that the pivot side remains snapped. 6. Secure the door frame to the side panels by installing six (6) #8 x 3/4” flat head screws through the pre-drilled holes and into the side panels 7. Secure the side panels to the wall jambs with six (6) #6 x 3/8” pan head tek screws.
