ES-2 Soap Dishes Product Warnings Safety Guidelines Kit Contents Required Tools Preparation Tips Installation Procedure Cleaning & Maintenance Surface Repair Warranty Information R ea B da ef n or d e Un In d st er al s lin ta g nd Register your warranty at www.swanstone.com.
Safety Guidelines IMPORTANT NOTICE The Swan Assurance — if our product is properly installed and maintained, as stated in these instructions, it will not leak. Remember – Safety First IMPORTANT NOTICE The Swan Corporation, the makers of the Swan products, cannot anticipate every possible circumstance that might involve a potential hazard during the installation of our product(s). The warnings and instructions in this installation guide are, therefore, not all-inclusive.
Safety Guidelines General Information Eye Protection Be sure to use all personal protective equipment to ensure your own safety. To avoid eye injury, always wear protective glasses with side shields when using power tools. Also, make sure no one else can be injured by flying particles when using power tools. Electrical Shock Hazard Contacting live electrical wiring with power tools or hand tools can cause serious injury or death. Make sure all related circuit breakers are turned OFF.
Installation Procedure Installation Procedure Clean each wall panel with denatured alcohol or another non oil-based cleaning solvent where the soap dish will be installed. Followed carefully, these installation instructions will result in an easy, trouble-free installation of your Swanstone product. Any deviations, additions, and/or deletions from the prescribed installation, without prior written approval, will void the warranty covering this product.
Installation Procedure 2. After marking the height, draw a 4” level-line on both walls. These lines will be used to align the top edges of the soap dish. WARNING 4. Apply clear silicone to the edge of the soap dish. 5. Align the soap dish with the level-lines and press it into place. 6. Hold the soap dish securely in place and wipe off excess clear silicone. You will want a uniform bead on both top and bottom. 7. Temporarily secure the soap dish with masking tape, as shown.
Maintenance & Cleaning Warranty Care and Cleaning Warranty The Swanstone products are stain and abrasion resistant; however, the finish requires reasonable care. If a Swanstone product covered by this warranty is found to be defective in materials or workmanship, after inspection by an authorized Swan Corporation representative, we will repair, or at our option, exchange the product for a similar model.
Save these Installation Instructions for future reference. They provide important information on cleaning, maintenance, and surface repair of the Swanstone Wall Systems and Panels. www.swanstone.
