Installation Guide

Fumes Hazard
The fumes from the silicone adhesive
and solvents used by the installer can
be harmful if used in an unventilated
room. Always work in a well-ventilated area. To keep the
area well-ventilated, open windows and use exhaust fans.
If adequate ventilation is not achievable or practical, use
respiratory protective equipment.
2. Clean the back of the panel with denatured alcohol.
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the
panel from properly adhering to the wall.
3. Apply the silicone adhesive in 1-1/4 inch diameter
dots every 8 to 10 inches over the back surface of
the panel. Follow the silicone manufacturer’s
instructions and note all ventilation and installation
precautions.
4. Carefully position the corner panel and firmly press
the surface of the corner panel against the walls.
Apply hand pressure up and down and side-to-side,
making sure all areas are in firm contact with the
wall. It is important to apply hand pressure to the
entire surface of the panel to bond it to the wall
surface.
5. Except for corner shower wall kits, repeat Step 1
through Step 4 to install the remaining corner panel.
Note: Make sure the top edge of both corner panels are
at the same height, measured from the top of the
bathtub or shower floor ledge.
IMPORTANT NOTICE
WARNING
800-325-7008 13 The Swan Corporation
Installation Procedure