Instructions / Assembly

INCLUDED IN THE CARTON:

A Sill panel

B Right jamb panel

C Left jamb panel

D One tube of adhesive

E One tube of white caulk

Installation instructions

TOOLS REQUIRED TO INSTALL

The only tools needed are a saber saw, ruler and

caulking.

DO NOT NAIL PANELS TO SILLS. THE HOLES

IN THE PANELS ARE FOR MANUFACTURING

PURPOSES ONLY!

INSTALLATION PROCEDURE

Allow panels to adjust to room temperature for at

least 6 hours (65⬚–90⬚F).

Remove unnecessary window moldings, if any,

and clean area of dirt, chipped paint, loose plaster,

etc.

Installation procedure for

FIBERGLASS WINDOW TRIM KIT WTK-1/BC-8100

CAUTION: Read ALL instructions BEFORE

starting your installation. Save this manual for future reference.

Pat. No. 4,391,072

PAGE 1
Installation procedure for FIBERGLASS WINDOW TRIM KIT WTK-1/BC-8100 Pat. No. 4,391,072 CAUTION: Read ALL instructions BEFORE starting your installation. Save this manual for future reference. INCLUDED IN THE CARTON: A B C D E Sill panel Right jamb panel Left jamb panel One tube of adhesive One tube of white caulk Installation instructions TOOLS REQUIRED TO INSTALL The only tools needed are a saber saw, ruler and caulking. DO NOT NAIL PANELS TO SILLS.
PAGE 2
IMPORTANT — Adhesive Venting Instructions The adhesive manufacturer recommends the following procedure be used to prevent the possibility of adhesive bleed through when attaching to a nonporous surface, such as ceramic tile or vinyl coated dry wall: After adhesive is applied to panel as instructed, DO NOT remove backing from tape. Position panel as instructed and press firmly against the wall. Pull panel away from the wall and allow the adhesive to dry for three (3) minutes.