Manualshelf

User's Manual

ManualsBrandsSwarm Link ManualsElectronicsISA100 wireless transmitter for ultrasound corrosion data
11121314151617181920
Doc. No. 702202-252-01 rev. 00
Page 12 of 42
Swarm®S2 Installation and User Manual
Last updated 2021-03-02
by Harald Sleire
© Sensorlink Swarm AS 2021
Step
Description
Illustration
5.
Insert one of the free ends of the band into the slit of the buckle
from the upper side.
6.
Pull the free end of the band through the buckle approximately
50 cm. Make sure the band is thoroughly folded as the brackets
should be able to slide over.
7.
Bend the steel band back at approximately 15cm to leave
approximately 30cm under the buckle as shown in the picture.
NB! Make sharp folds on the steel band. The sensor brackets
shall be able to slide over the folded steel band if they shall be
located close to the buckle.
8.
Insert the free end of the band into the first bracket to be
installed.
9.
Repeat until you have all the brackets to be installed on the
band.