User's Manual

Doc. No. 702202-252-01 rev. 00
Page 3 of 42
Swarm®S2 Installation and User Manual
Last updated 2021-03-02
by Harald Sleire
© Sensorlink Swarm AS 2021
1 Introduction
The purpose of this manual is to give field engineers, installation personnel, and end user sufficient information to be
able to do safe installation and operation of the PipeMonit® Swarm® S2 in an Ex Hazardous zone. The document is
structured in four main sections, one describing the product family, one describing the physical installation, one
describing the configuration of the system via the service port (Bluetooth®) and ISA100 network and the final one
describing safe operation.
Note: This manual does not contain how to setup or build up an ISA100 wireless infrastructure (network), it is
assuming that wireless infrastructure is installed and operational when attempting to initiate the Swarm S2
ISA100 versions.
1.1 Warnings and safety notice
Modifications
Changes or modifications to the equipment not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Interference
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
This Device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage ; (2)
l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Exposure
To comply with FCC/IC RF exposure limits for general population / uncontrolled exposure, the antenna(s) used for
this transmitter must be installed on outdoor permanent structures to provide a separation distance of at least 20
cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.