USER GUIDE 1
Contents USER‘S MANUAL CONTENTS CHAPTER PAGE Introduction 3 Important notes 4 Safety notes 4 Symbols Used 5 Signal Strength 5 Getting started 6 service 6 Use your SWATCH® Paparazzi 7 Activate the Storage battery / Charging 9 Channels Navigation structure 10 11-12 Services „Watch“ functions 13 Time setting (Set time) 13 Choosing a „Face“ 14 Watch face channel update 15 „Chrono“ mode (chronograph) 15 „Alarm“ mode 16-18 „Timer“ mode 19-20 21 „Settings“ mode Frequently Asked
Introduction Congratulations! Thank you for choosing a SWATCH® Paparazzi. Your new watch can perform traditional time measurement, such as time indication, timing, countdown, and alarm functions. However, the novel feature of your SWATCH® Paparazzi is a new wireless communication technology which enables your watch to receive data directly from the service (www.msndirect.com).
Introduction Important notes Your SWATCH® Paparazzi is delivered in OFF mode (see page x) and has been 100% charged on leaving the factory. It may, however, be necessary to partially recharge it (see the charging procedure on page 9). The information is transmitted by FM radio. The quality of reception may therefore vary depending on the place in which you are located (see notes on signal coverage on page x). Your SWATCH® Paparazzi is water-resistant at up to 2 ATM.
Introduction Never touch the mains adapter with wet hands. Never dismantle the mains adapter or the watch plug. Do not try to dispose of the adapter by incineration. During storms, it is recommended disconnecting the mains adapter. Avoid any extended contact with the mains adapter when it is energised with your watch undergoing charging. Keep the mains adapter out of reach of young children. Do not place the power cord near a radiator or other source of intense heat.
Getting started Step 1: Getting started Your SWATCH® Paparazzi is delivered in OFF mode and has been 100% charged on leaving the factory. It may, however, be necessary to partially recharge it (see charging procedure on page 9). A. Unpackage and start your watch 1. Remove your watch and the charger from the packaging. 2.Simultaneously press the PREVIOUS, ENTER and NEXT buttons. This operation causes your watch to restart (“Reset”).
Use Step 3: Use your SWATCH® Paparazzi �� ������ ������ ����� �� ��� �� ����� After you‘ve activated and personalized the service, your watch is ready to use. Within 12 hours, you‘ll receive a welcome message indicated by the icon on the screen ( ), and your personalized content. To read the welcome message, press MODE (CHANNEL) until you hear a beep... ... and then press PREVIOUS or NEXT several times until the Messages screen is displayed.
Use Power Reserve Depending on how it is used, your SWATCH® Paparazzi provides you with a power reserve of four or five days. After that, an alert screen will notify you that it is time to recharge the watch. When the watch battery is fully charged, it is at 100%. When the watch battery is fully discharged, it is at 0%. Your SWATCH® Paparazzi is fully functional from 100% down to a 20% charge. The following table describes how the watch responds at different battery charge levels.
Use Charging Set up the charger Unwind the cord completely. Connect the charger to a power outlet. Carefully connect the plug to your watch, inserting it horizontally. Charge your watch Leave your watch connected until Charged is displayed on the screen. About two hours are needed for your watch to completely charge. During recharging, your watch receives and displays the information. Depending on use, the charge should last three to five days.
Use Modes Each channel has one or more modes. For example, the Time channel includes the Face mode, the Chrono mode, the Alarm mode, the Timer mode, and the Settings mode. The name of the current mode appears on the SWATCH® Paparazzi screen. To view the current mode, press Channel once. To view the next mode within that channel, press Next.
Use Services Press PREVIOUS or NEXT to choose your message content: �������� Messages - Use the Messages channel to receive text messages. You will receive messages from: �������� SWATCH Meet - Get dating tips from a celebrity, find out about the hottest dating events in your city, or win a VIP dating contest! 5:17P 12 ����� �� SWATCH City - Stay informed about new hot spots, the best bars in your city, free events, and much more.
Use Weather Weather Scan weather reports for major cities in the world. View current local weather conditions (wind, humidity, barometric pressure, and UV index), three-day forecasts, and more. Sports Choose your favorite sports news and results for all important sports events. Sports Stocks Follow all of the important indices, and track your favorite stocks. Stocks Horoscope Get your daily horoscope or choose the horoscope of your friends, boss or police officer.
Use “Watch” functions With the “Time” channel, your SWATCH® Paparazzi has all the customary functions of a digital watch, although with a few improvements: Time (two time zones), in different forms of display. Chronograph (with one or more time splits) Two alarms (the first exclusively over 24hours and the second daily, weekly or occurring at a given date).
Use If your watch is not receiving a signal, you can manually set the time. You can also change the time display from a 12 hour clock to a 24 hour clock, and you can override the automatic time zone setting. For details, see “Changing Watch Settings” on page 21.
Use Watch Face Channel update Thanks to the services, you can change the look ® of your SWATCH Paparazzi. Customize your watch with season’s watch faces! You can keep two seasonal watch faces on your watch at a time. Please note: All the original faces are preserved. Watch faces are available for update at the Site www.msndirect.com. Web “Chrono” mode To access the “Chrono” mode, refer to the navigation diagram in the “Time” channel described on page 10.
Use Precise measurement of a period oftime withe time split(s) Press PREVIOUS to start measurement ����� ���� � �� �� �� �� ���� �� �� �� �� ����� �������� Press NEXT to display a time split (the display restarts after approx. 7 secs) Repeat as many times as you want.
Use “Alarm” mode Your SWATCH® Paparazzi includes two alarms, each having its own settings and its own melody. To access the “Alarm” mode, refer to the navigation diagram in the “Time” channel described on page 10. Step 1: Selecting and activating or deactivating the alarm ����� � ����� ��� ���� ������ ������ �� � Press PREVIOUS to activate or deactivate alarm 1, then, if necessary, on ENTER to switch to alarm 2. then again on PREVIOUS to activate or deactivate alarm 2.
Use Step 3: Setting alarm 2 ����� � ����� ��� ����� � ������ ���������� ����� � ����� ��� ������� ��� � ������� � � ������� � EVERY DAY First select alarm 2, then press NEXT to select the daily alarm (every day), then confirm with ENTER. Then perform settings for alarm 1 as described in step 2 on page 17. ON A SPECIFIC DATE Press NEXT to select the specific alarm (custom), then confirm with ENTER.
Use “Timer” mode Your SWATCH® Paparazzi has a “Timer” function adjustable from 1 second to 23 hours, 59 minutes and 59 seconds. To access the “Timer” mode, refer to the navigation diagram in the “Time” channel described on page 10. To activate or deactivate the “Timer” Press PREVIOUS to start the timer...
Use To set the „Timer“ mode Press NEXT to enter timer setting mode... ��� ���� ����� � ������� � then press PREVIOUS and NEXT to set the timing period (in minutes), then press ENTER to confirm, set the period in seconds and then in hours... then finally confirm by pressing ENTER. �������� � �� � � � � ����� Dismissing the timer notification ���� �� ��� When the timer countdown reaches zero, your watch emits for 1 minute a series of beeps and displays a notification message on your watch face.
Use “Settings” mode You can perform a number of settings on your Swatch Paparazzi. To do so, simply choose the “Settings” mode in the “Time” channel and refer to the navigation diagram in the “Time” channel described on page 10. �������� ������ ���� � ���� ������� ������ ������ ����� ������ ����� ��� �� ITEM � ������� � � ������� � � ������� � Choose the desired setting using PREVIOUS and NEXT then confirm by pressing ENTER. The selected setting is indicated by a black bar (see illustrations).
Use / FAQ‘s „Splash Delay“ To set time lag before automatic entry into channel (Time, Glance, News, etc). „Watch Info“ This mode displays a variety of information, in particular the power of the radio signal, the storage battery charge level and the name of the radio station ti which you SWATCH® Paparazzi is connected. „Watch Off“ To increase your watch‘s battery life, for example during a period of non-use, you can place it in „sleep“ mode („Watch Off“).
FAQ‘s How do I extend the battery‘s life? Choose a simple watch face, with few animations. Use only the „Time“ channel. Make sure that the „Audio“ setting is on „ALL OFF“. Stop radio reception by placing the „Radio“ setting on „OFF“. Place your watch in „sleep“ mode (see page 21). How do I set the time on my watch? So long as you are in an area covered by , you should not have to set the time by hand. Your watch is radiosynchronized with a reference clock.
FAQ‘s My watch does not display the correct time. What should I do? When you start your watch for the first time, the time shown is 12:00 A.M. When the watch receives a signal, it automatically places itself on the correct local time (generally in a few minutes). The reception covers most metropolitan areas in the United States and Canada. If your watch is located in one of these areas, it will receive the correct local time automatically (unless the watch‘s „Radio“ setting is on „OFF“).
FAQ‘s My watch has received no new information for one day or more. What should I do? The reception covers most metropolitan areas in the United States and Canada. If your watch is located in one of these broadcasting areas, it should automatically receive the information broadcasted (news, weather reports, etc.). If your watch is located outside a broadcasting area, it receives no new information until you return into this area. For any further information concerning coverage areas, go to the www.
General information Terms and Conditions Warranty With effect from the date of purchase, SWATCH Ltd. grants you a twenty-four (24) months warranty for your SWATCH® watch, under the terms defined in the additional warranty leaflet. The SWATCH® international warranty covers defects of materials and workmanship existing at the time of delivery of the SWATCH® watch purchased (“the defects”).
General information CE and FCC conformance The CE mark on the back of your watch indicates that it is in conformity with the European Union EMC directive 89/336/EEC. General informations It is also in conformity with section 15 of the FCC restrictions concerning class B digital devices, which means that this equipment generates, uses and can emit radiofrequency waves and, if it is not installed or used in accordance with the instructions, may cause interferences harmful to radio communications.
