Operation Manual

The configuration at the back of the monitor may vary from product to
product.
1. Power port
2. VGA-Signal port
3. S-Video port
4. Composite Video port
5. Audio-in left
6. Audio-in right
7. Audio-in from PC
8. Audio-out from Monitor
Note: See "Connecting your monitor" for further Information regarding cable
connections.
Introduction
Rear
User’s Manual
7
Connecting The Monitor
1. Connect the power cord for the monitor to the power port on the back of the
monitor, Plug the power cord for the monitor into a nearby outlet.
2. Connect the VGA-signal cable to the VGA D-sub connector on the back of the
monitor, or connect the monitor to another device through the S-video or
Composite Video ports
3. If you are using a Macintosh computer, connect the cable to a Macintosh adapter,
and set the pins on your adapter (Adapter not included). PC-conpatible
computers do not need an adapter.
4. When connecting to a computer, turn on the computer and monitor. If the
monitor displays an image, installation is complete.
Rear
Navigate the OSD
How to navigate the OSD menu?
1. Push the Menu button to enter the OSD menu.
2. Use the up/down buttons to select a main
category.
3. Push the Menu button to enter the main
category you selected in the step 2.
4. Use the up/down buttons to select the sub
category you want to adjust.
5. Use the +/- button to adjust to a desired
value.
6. Push the Menu button to exit the category and push the Menu button again to
exit the OSD.
OSD - MENU
Brightness 86
contrast 50
h position 50
v position 50
phase 50
clock 1344
scaling fill all
?
picture
advanced
pip
adv pip
options
utilities
- +
- +
- +
- +
- +
- +