User's Manual

©2019 SwellPro All Rights Reserved
03
This section introduces the remote controller functions, including the drone operation and the camera
operation.
Remote Controller
Low Battery Alarm
The Spry remote controller has a built-in battery and charging circuit. Charge the controller using the
supplied micro-USB cable and a regular 5V /2A USB charger. Some USB ports and some USB cables cannot
provide the full 2 amps (2A) of power required. These ports and cables can still be used to charge the Remote
Controller but the charging time will be longer. Normal charging time is ~90 minutes.
During charging, the remote controllers power button will glow blue. When charging is complete the blue
light will turn off. Charging is possible during flight if necessary, but the remote must be connected to the
drone before connecting the charging cable.
The remote control has a built-in lithium battery and the operating time is about 2 hours. When the remote
controller battery is low, the remote control will beep and the battery power icon in the upper right corner
of the screen will be red. The remote control will then have approximately 10 minutes of power left. It is best
to return the drone and land as soon as possible or plug in the controller to charge the battery.
The Spry Remote Controller operates using two frequency bands, 2.4GHz and 5.8GHz. The 2.4GHz band is
used for drone control and 5.8GHz is for the FPV video signal. The remote control has a built-in 4.3-inch FPV
screen that displays real-time images and flight data of the aircraft.
Remote Controller Operation
Power ON and Power OFF
One Key Return Home
DescriptionRemote Control Operation
DescriptionRemote Control Operation
Power on: Long-press the power button for 3 seconds, the remote
controller will vibrate, beep and screen will turn on.
Power off:
Long-press the power button again for 3 seconds to turn off
the remote control.
On:
Long-press the Return Home switch until the the controller beeps.
The aircraft enters the return state, and the FPV screen will display “RTH”.
Cancel Return Home:
Long-press the Return Home switch until the
controller beeps.
Return Home
Charging Remote Controller Battery