Manual

Rouchon Industries, Inc., dba Swiftech - 3700 Industry avenue, suite 104, Lakewood CA 90712- Toll free (US) 866-857-9438 -

Fax 562-595-8769 -

E Mail: help@swiftech.com - URL: http://www.swiftech.com - Information subject to change without notice

Thank you for purchasing the 7950 GX2 Spacer kit. This product is intended for expert users. Please consult with a qualified

technician for installation. Improper installation may result in damage to your components. Swiftech™ assumes no liability

whatsoever, expressed or implied, for the use of this product, nor its installation. The following instructions are subject to

change without notice. Please visit our web site at www.swiftech.com for updates.

VGA compatibility

The 7950 GX2 spacer kit is only compatible with the GeForce 7950 GX2

Packing list

Quantity Part Description

3 # MF800 Male-Female 4-40 x 0.800” Standoff

1 # TA800 Pass-thru female 0.800” Standoff

1 #FF706 Female-Female 4-40 x 0.706” Standoff

1 Screw 4-40 x Philips screw

1 Ramsink 1 MC14 Ramsink

1 7950EB Extended PCB

Installation Guidelines

Step-by-step

First step

Turn the graphics card over

and remove the one screw

holding to the PCI bracket

Step 2

Turn the graphics card over

and remove all 4 screws

shown above (keep them; you

are going to reuse them).

Step 3

Carefully separate the 2 cards.

Step 4

Remove the stock PCB.

Step 5

Install Swiftech’s extended PCB

provided with your kit.

Step 6

Insert the Female pass-thru

standoff between the card and the

PCI bracket

PAGE 1
Thank you for purchasing the 7950 GX2 Spacer kit. This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your components. Swiftech™ assumes no liability whatsoever, expressed or implied, for the use of this product, nor its installation. The following instructions are subject to change without notice. Please visit our web site at www.swiftech.com for updates.
PAGE 2
Step 7 Insert the provided 4-40 screw thru the card and into the Female pass-thru standoff. Step 8 Screw the female-female threaded standoff over the PCI bracket Step 9 Screw all 3 Male-female standoffs to those of the card. You now have 4 extended standoffs, and are ready to complete the installation in the next two steps. Step 10 Install the provided MC14 Ramsink on the SLi chip of the main board as shown above Step 11 Assemble the 2 cards. Make sure that the PCB is correctly aligned.