Owner manual

ManualsBrandsSwiftech ManualsComputer AccessoriesAPOGEE XT MULTI HDP AMD

Street, Long Beach, CA 90805 – Tel. 310-763-0336 - Toll free (US) 888-857-9438 – Fax 310-763-7095 - E Mail: help@swiftech.com – URL: http://www.swiftech.com -

Information subject to change without notice

APOGEE

™

XT – MULTI MOUNT ADAPTER PLATE

AMD® INSTALLATION GUIDE – GUIDE D’INSTALLATION – GUÍA D’INSTALACIÓN

Remove the stock hold down-plate

Using the provided Hex key loosen all 6 body screws, and set aside the

plate with its mounting screw springs.

Install the Multi-mount hold-down plate

Using the provided Hex key fasten the plate to the block with all 6 body

screws

Démontez la plaque de rétention d’origine

Utilisez la clef Allen fournie pour dévisser les 6 vis come indiqué ci-

dessus.

Remontez la plaque de rétention multiple

Utilisez la clef Allen fournie pour revisser les 6 vis come indiqué ci-

dessus.

Desmonte la placa de retención de origen

Utilizando la llave proporcionada para desatornillar los 6 tornillos como

se indica arriba.

Remonte la placa de retención de origen

Utilizando la llave proporcionada para atornillar los 6 tornillos como se

indica arriba.

Prepare the motherboard: AMD 754, 770, 939, 940, AM2,

AM3

Remove the motherboard plastic frame surrounding the socket.

Prepare the CPU

Clean the CPU with a degreaser (preferably formulated for electronics)

then apply the supplied grease to the center of the CPU.

Préparez la carte-mère : AMD 754, 770, 939, 940, AM2,

AM3

Démontez le cadre en plastique qui entoure le microprocesseur.

Préparez le microprocesseur

Nettoyez le CPU avec un dégraissant (de préférence spécialement

conçu pour les composants électroniques), puis appliquez la pâte

thermique fournie au centre du CPU.

Summary of content (3 pages)

PAGE 1
APOGEE™ XT – MULTI MOUNT ADAPTER PLATE AMD® INSTALLATION GUIDE – GUIDE D’INSTALLATION – GUÍA D’INSTALACIÓN 1 2 Remove the stock hold down-plate Using the provided Hex key loosen all 6 body screws, and set aside the plate with its mounting screw springs. Install the Multi-mount hold-down plate Using the provided Hex key fasten the plate to the block with all 6 body screws Démontez la plaque de rétention d’origine Utilisez la clef Allen fournie pour dévisser les 6 vis come indiqué cidessus.
PAGE 2
Prepare la placa base: AMD 754, 770, 939, 940, AM2, AM3 Desmontar el marco en plástico que rodea el microprocesador. 5 Prepare el microprocesador Limpie el CPU con un desengrasante (preferentemente especialmente diseñado para los componentes electrónicos), y aplique la pasta térmica incluida en el kit en el centro del CPU. 6 AMD socket AM2, AM3 installation For this installation, you will be keeping the existing motherboard backplate.
PAGE 3
7 Install the tubing The coolant inlet is identified by a detachable plate. It is factory installed in its optimum position but can also be rotated 180° to allow the installation of large compression fittings (G ¼ standard thread). Some thermal and hydraulic performance degradation is inevitable when the plate is rotated. Finally, fasten the tubing to the inlet and outlet fittings with the provided hose-clamps.