Instructions / Assembly

FIGURE 13

exit section

FIGURE 14

1-1/2" bolt

2" x 4" x 8-1/4"

2" x 4" x 7"

2" x 4" x 18"

2-1/2" screws

washer

loc nuts

2" x 4" x 8-1/4"

FIGURE 16

FIGURE15

1-1/2" lag bolts

support bracket

Fig. 6

Fig. 6a

Fig. 6b

Fig. 6c

F. SUPPORT AND BRACKET

ASSEMBLY

1. Position the slide bracket as shown in (FIG. 6).

Remove appropriate bolts from the slide (the fourth and

fifth bolts as indicated), Attach bracket to the underside

of the seam using the previously removed hardware

(FIG. 6).

2. Using holes in the bracket (indicated by arrows in

(FIG. 6)) as a guide, mark and drill 1/8" pilot holes

(1" deep). NOTE: You may need to temporarily

remove the slide bracket to drill the pilot holes.

3. Re-attach bracket (if necessary) and secure it to the

4'' x 4'' Slide Support using two 1-1/2" lag bolts .

4. Assemble the support base as shown in (FIG. 6a).

5. Attach the support bracket to the support base using

two 1-1/2" lag bolts (FIG. 6c).

NOTE: Pre-drill 1/8" pilot holes.

6. Place the support beneath the slide base and determine

its final position. NOTE: Slide support should fit tightly

beneath the slide to assure proper support. Remove

corresponding nut and bolt, attach support to the slide

as indicated in (FIG. 6b). Re-attach hardware.

7. Level grade at the bottom of the slide.

slide bracket

4'' x 4'' x 66''

Tunnel Twister Assembly Instructions