Instructions / Assembly

RAIN WHEEL:
1. Choose a desired location for the Rain Wheel and drill a 5/16” diameter hole through the lumber.
NOTE: If lumber is greater than 2” in depth, you will need to counterbore the hole appropriately.
2. Tap Carriage Bolt into wood to allow threads to start easily.
3. Mount Rain Wheel to climbing unit. Note: Do not overtighten Bolt. Wheel should spin.
4. Snap Rain Wheel cap into place.
Carriage Bolt
Flat washer
Loc nut
Spacer
Rain Wheel Cap
Mounting Instructions
To Purchase Additional Accessory Kits, Please Visit www.swing-n-slide.com
© PlayCore Inc. 2009 Printed In USA LA 6045
BABALOO DRUM:
1. Mount the Babaloo to the 2'' x 4'' x 8-1/4'' support board as shown in (Fig. 1).
2. Choose a desired location for the Babaloo Drum, at least 9'' from any barrier opening.
3. Mount Babaloo and the 2'' x 4'' x 8'' to unit barrier as shown in (Fig. 2).
(Fig. 1)
(Fig. 2)
BONGO DRUMS:
1. Choose a desired location for the Bongo Drums, at least 9’’ from any barrier opening.
2. Attach 2'' x 4'' x 8-1/4'' as shown in (Fig. 3). Make certain 2'' x 4'' is ush with top of barrier.
3. Mount the Bongo Drums to the 2'' x 4'' x 8-1/4'' support board as shown in (Fig. 4).
Note: Barrier removed in image for clarity.
(Fig. 3)
(Fig.4)
(2) 1/4'' Washers
(2) 1'' Truss Head Screws
(4) 2'' Deck Screws
(4) 2-1/2'' Deck Screws
(2) 1/4'' Washers
(2) 1'' Truss Head Screws
FLUSH
FLUSH