Instructions / Assembly

90°
90°
You will assemble two A-frame post assemblies.
1. Place two posts side-by-side on a at surface.
2. Temporarily insert two 5” carriage bolts to keep posts square for pre-drilling.
It's important to drill holes square to holes in posts.
3. Measure and mark holes. Drill pilot holes to size shown.
4. Move posts apart and locate and attach A-brace as shown.
Tighten screws snug but do NOT fully tighten screws on brace yet.
Temporary carriage bolts
3-1/4 Dia. x 93" Plastic-Coated Posts (x2)
45"
1/8" pilot holes
!
Note: Fasteners should be
snug at this point.
1/4 x 2-1/2"
Panhead Screw
1/4" flat washer
1/4" lock washer
Weep Holes
A-Brace
!
!
8